Difference between revisions of "Unit RPIGPIOEXPANDER"
(Created page with "Return to Unit Reference === Description === ---- ''To be documented'' === Constants === ---- ''To be documented'' === Type definitions === ---- ''To...") |
|||
| Line 5: | Line 5: | ||
---- | ---- | ||
| − | '' | + | '''Raspberry Pi Firmware GPIO Expander Driver''' |
| + | |||
| + | As of February 2017 the Raspberry Pi firmware contains a mailbox interface to allow control of the GPIO expander on the Raspberry Pi 3 and Compute Module 3. | ||
| + | |||
| + | Unlike the earlier virtual GPIO interface this mailbox service now supports most GPIO functionality including getting and setting a pin value, getting and changing the pin function and getting or changing the pull up/down options. | ||
| + | |||
| + | This driver implements most of the functionality available in the new mailbox service as a standard Ultibo GPIO device and also provides direct mailbox calls to allow access to any additional options not covered by the GPIO device API. | ||
| + | |||
| + | When included in a project this driver replaces the Virtual GPIO functions provided by the PlatformRPi2 and PlatformRPi3 units. | ||
| + | |||
| + | According to /arch/arm/boot/dts/bcm2710-rpi-3-b.dts the following pin assignments are known: | ||
| + | |||
| + | * GPIO_PIN_2 = Activity LED | ||
| + | * GPIO_PIN_4 = HDMI Detect (Input / Active Low) | ||
| + | * GPIO_PIN_7 = Power LED (Input / Active Low) | ||
| + | |||
| + | Note that this driver requires the most recent firmware (later than February 2017) and has been tested successfully with the firmware release from 22 May 2017. | ||
| + | |||
| + | The latest version of the firmware is available from https://github.com/raspberrypi/firmware | ||
=== Constants === | === Constants === | ||
Revision as of 03:52, 13 June 2017
Return to Unit Reference
Description
Raspberry Pi Firmware GPIO Expander Driver
As of February 2017 the Raspberry Pi firmware contains a mailbox interface to allow control of the GPIO expander on the Raspberry Pi 3 and Compute Module 3.
Unlike the earlier virtual GPIO interface this mailbox service now supports most GPIO functionality including getting and setting a pin value, getting and changing the pin function and getting or changing the pull up/down options.
This driver implements most of the functionality available in the new mailbox service as a standard Ultibo GPIO device and also provides direct mailbox calls to allow access to any additional options not covered by the GPIO device API.
When included in a project this driver replaces the Virtual GPIO functions provided by the PlatformRPi2 and PlatformRPi3 units.
According to /arch/arm/boot/dts/bcm2710-rpi-3-b.dts the following pin assignments are known:
- GPIO_PIN_2 = Activity LED
- GPIO_PIN_4 = HDMI Detect (Input / Active Low)
- GPIO_PIN_7 = Power LED (Input / Active Low)
Note that this driver requires the most recent firmware (later than February 2017) and has been tested successfully with the firmware release from 22 May 2017.
The latest version of the firmware is available from https://github.com/raspberrypi/firmware
Constants
To be documented
Type definitions
To be documented
Public variables
None defined
Function declarations
To be documented
Return to Unit Reference
